Marking The Location - IBM Power 730 Express Manual

Hide thumbs Also See for Power 730 Express:

Table of Contents

Figure 1. Removing the filler panels

4. If necessary, remove the front and rear rack doors.

Marking the location

Learn how to mark the position on the rack for installing the slide rail.

To mark the installation location, complete the following steps:

1. Facing the front of the rack and working from the right side, locate the bottom EIA unit that your

system will use. Make a note of the EIA location. Use tape, a marker, or a pencil to mark the bottom

hole of this EIA unit as A, as shown in Figure 2 on page 5. Mark the rack so that the mark can also be

seen from the rear of the rack.

Note: Use the marked holes to determine where to locate the slide rails, and attach them by using the

pins.

Power Systems: Installing the IBM Power 710 Express (8231-E1C) or IBM Power 730 Express (8231-E2C)

Table of Contents

Power 710 express 8231-e1c 8231-e2c