Table of Contents
Advertisement
36
en | Camera
6.13
PTZ Settings
Auto pan speed
Continuously pans the camera at a speed between right and left limit settings. Type a value
between 1 and 60 (expressed in degrees), inclusive. The default setting is 30.
Inactivity
Selects the time period the dome must be not controlled until the inactivity event will be
executed.
–
–
–
Inactivity period
Determines the behavior of the dome when the control for dome is inactive. Select a time
period from the pull-down list (3 sec. - 10 min.). The default setting is 2 minutes.
Auto pivot
The Auto pivot tilts the camera through the vertical position as the camera is rotated to
maintain the correct orientation of the image. Set the Auto Pivot to On (default) to
automatically rotate the camera 180º when following a subject traveling directly beneath the
camera. To disable this feature, click Off.
Freeze frame
Select On to freeze the image while the camera moves to a predetermined scene position.
Pan limit left
Set the appropriate pan limit on the left.
Pan limit right
Set the appropriate pan limit on the right.
Tour A / Tour B
Starts and stops the recording of a recorded (guard) tour.
The camera can make up to two (2) recorded tours. A recorded tour saves all manual camera
movements made during the recording, including its rate of pan, tilt and zoom speeds, and
other lens setting changes. The tour does not capture camera video during the recording of
the tour.
Note 1: You can save a total of 15 minutes of recorded actions between the two tours.
To record a tour:
1.
2.
3.
4.
5.
Note: Tour B is now intended for use with the 'IVA while moving' functions.
You must first calibrate the camera to North before the camera displays accurate compass
headings. The camera uses this calibration, usually set to magnetic North, as the zero degree
pan position and as the North compass heading. The camera then displays the compass
heading based on the number of degrees from the North calibration point.
To set the North calibration point:
1.
2.
3.
2018.11 | 1.1 |
Off (default): camera remains on a current scene indefinitely.
Pre-position 1: camera returns to Pre-position 1.
Previous AUX: camera returns to the previous AUX activity.
Click the Start Recording button. The system prompts you to overwrite the existing tour.
Click Yes to overwrite the existing tour movements.
Click the View Control link, under the image cameo, to access the directional and zoom
controls.
Use the View Control dialog box to make the necessary camera movements.
Click the Stop Recording button to save all actions.
Determine the North compass heading, then move the camera to that position.
Select the radio button On for the parameter Compass.
Click the button next to North point to set the calibration point.
User Manual
AUTODOME IP starlight 5000i
Bosch Security Systems
Advertisement
Table of Contents
