Agilent Technologies 85057B User's And Service Manual page 30

4. Assemble the airline and center conductor (refer to
CAUTION Wear gloves while performing the following steps. You will be touching the
exposed center conductor of the airline. Do not transfer oil or dirt from your
fingers to the center conductor. See
a. Remove the center conductor from its plastic case. Make sure you select the correct
center conductor for the airline you are connecting. Refer to
Figure 2-4 on page 2-6
b. Remove the protective end cap from the female end (the end without the connecting
nut) of the outer conductor.
c. Leave the protective end cap on the male end of the airline to prevent the center
conductor from falling out of the outer conductor.
d. Insert the center conductor into the outer conductor so that the female end of the
center conductor is toward the female end of the outer conductor (the end without
the connector nut). Refer to
Figure 3-4 Assembling the Airline and Center Conductor
5. Attach the short:
a. Without turning the airline or the short, connect the airline to the short by
interconnecting the male and female connectors. Connect the nut finger tight. Do not
overtighten.
b. Using an open-end wrench to keep the device body from rotating, use the torque
wrench recommended for use with this kit to tighten the connecting nut to the
specified torque. Refer to
additional information.
c. Remove the protective end cap from the male end of the airline.
85057B
"Handling and Storage" on page
for illustrations of both center conductors.
Figure 3-4.
"Final Connection Using a Torque Wrench" on page 3-14
Use, Maintenance, and Care of the Devices
Figure 3-4):
Figure 2-3
Gaging Connectors
3-18.
and
for
3-11