Table of Contents
Advertisement
d. Press and release the SYNC. Button on the inside of the SD card
compartment on the console.
e. Use a straightened paper clip to poke through the jacket, and then
press and release the SYNC. Button inside the Wii Remote. This step
must be completed within 30 seconds of the previous step.
When the Player LEDs stop flashing, one LED is illuminated to indicate
the player number (1 or 2).
f. After synchronizing the Wii Remote, verify the synchronization
information was stored by the Wii. Use the newly synchronized Wii
Remote to power OFF and then power ON the Wii.
7. If the Wii Remote did not synchronize, contact the Fun Center Support
Hotline (1-877-716-8550) for further troubleshooting assistance. Make
sure you have the Fun Center and the Fun Center tool kit on hand as you
will be asked to check internal connections in the Fun Center.
3.5 W
R
N
II
EMOTE AND
UNCHUK
SYNC. button locations
Information If there are lights on the Wii Remote,
you will be asked to check the connections described in
Section 3.9, "Bluetooth Connections" on page 30.
If there are no lights on the Wii Remote, you will be
asked to check the connections described in Section
3.10, "Wire Harness Connections" on page 31.
S
F
C
TARLIGHT
UN
O
M
ENTER
PERATION
ANUAL
18
31
OF
Advertisement
Table of Contents
