Download Print this page
Toro Z Master 116-0231 Installation Instructions
Toro Z Master 116-0231 Installation Instructions

Toro Z Master 116-0231 Installation Instructions

Roll-over protection system riding mower

Advertisement

Quick Links

Roll-Over Protection System
Z Master
Model No. 116-0231
Model No. 116-0232
Note: Determine the left and right sides of the machine
from the normal operating position.
Safety
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol (Figure 1),
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
Improper use or maintenance by the operator or owner can
result in injury. To reduce the potential for injury, comply
with these safety instructions and always pay attention to the
safety alert symbol, which means CAUTION, WARNING, or
DANGER-"personal safety instruction." Failure to comply
with the instruction may result in personal injury or death.
This product is capable of amputating hands and feet and
throwing objects. Always follow all safety instructions to
avoid serious injury or death.
This product is designed for cutting and recycling grass or,
when equipped with a grass bagger, for catching cut grass.
Any use for purposes other than these could prove dangerous
to user and bystanders.
WARNING
To avoid injury or death from rollover: keep the
roll bar in the raised locked position and use the
seat belt.
Ensure that the rear part of the seat is secured with
the seat latch.
© 2012—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Riding Mower
Figure 1
Register at www.Toro.com.
WARNING
There is no rollover protection when the roll bar is
in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar is
in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance permits.
• Check carefully for overhead clearances (i.e.
branches, doorways, electrical wires) before
driving under any objects and do not contact
them.
Keep the roll bar in the raised and locked position and
use the seat belt when operating the machine.
Be certain that the seat belt can be released quickly in
the event of an emergency.
Be aware there is no rollover protection when the roll
bar is down.
Check the area to be mowed and never fold the ROPS in
areas where there are slopes, drop offs or water.
Lower the rollbar only when absolutely necessary. Do not
wear the seat belt with the roll bar folded down.
Check carefully for overhead clearances (i.e. branches,
doorways, electrical wires) before driving under any
objects and do not contact them.
Form No. 3373-220 Rev A
Installation Instructions
Original Instructions (EN)
Printed in the USA.
All Rights Reserved

Advertisement

loading

Summary of Contents for Toro Z Master 116-0231

  • Page 1 Ensure that the rear part of the seat is secured with the seat latch. Register at www.Toro.com. © 2012—The Toro® Company Original Instructions (EN) 8111 Lyndale Avenue South Printed in the USA. Bloomington, MN 55420...
  • Page 2 Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. Remove an existing Rollover Protection – No parts required System (ROPS). Upper tube Right ROPS leg Left ROPS leg Carriage bolt (1/2 x 3-1/2 inch) Bolt (1/2 x 4 inch) Install the Rollover Protection System Round spacer...
  • Page 3 WARNING Ensure the fuel vent hoses are connected or fuel may leak and violate emissions regulations. • Do Not operate the unit unless the fuel vent assembly is installed. • Do Not weld, drill or modify roll bar in any way. 1.
  • Page 4 g0181 11 Figure 5 Use for kits with manual tubes only. 1. Manual tube 3. R-clamp 2. Bolt (1/4 x 5/8 inch) 6. Reconnect the negative battery cable. Figure 4 1. Carriage bolt (1/2 x 3-1/2 6. Curved washer inch) 2.

This manual is also suitable for:

Z master 116-0232