Table of Contents
Advertisement
Available languages
Available languages
Fig. R
b. Using supplied hex wrench, turn set screw
contacts stop
30
c. Using a square
31
and make sure the fence is 45° to the table. Adjust
the fence if necessary.
Fig. S
d. Using supplied hex wrench, turn set screw
contacts stop
33
.
Fig. T
e. These positive stops enable you to rapidly position
the table to the 90° and 45° settings.
CAUTION: Make sure the fence is in level contact with
the surface of the outfeed table.
Adjusting Knives (Fig. U–Y)
WARNING: The knives are sharp.
31
.
, tilt the table to the 45° position
32
33
WARNING: Disconnect machine from power source.
WARNING: Be extremely careful that your hands do
not come in contact with the knives.
WARNING: Make certain that all knives are securely
fastened in cutterhead before turning on power.
When it becomes necessary to replace or adjust the knives
due to replacement or wear:
1. Remove cutterhead guard.
2. To replace a knife, disengage the cutterhead lock
Rotate cutterhead, loosen four screws
bar and knife. Insert new knife and replace bar and
securely tighten four screws.
Fig. U
until it
29
3. To adjust the knives, make sure the cutterhead lock
is not engaged. Make sure screws are not overly
tightened. Loosen each one half turn or only enough so
knife can slide between locking plate and cutterhead.
4. Rotate cutterhead and engage cutterhead lock
32
until it
cutterhead shaft as shown. This will position knives for
proper adjustment to the outfeed table.
5. Place a straight edge
extending out over the knife as shown. Using hex
wrench supplied, turn screw
straight edge. Adjust knife at near end of cutterhead
in the same manner turning screw
screws
nOTE: Make sure cutterhead lock
adjustment is completed and replace cutterhead guard.
Fig. V
37
4
37
on the outfeed table
35
after adjustment is made.
34
4
English
4
.
34
and remove
34
4
4
on
until knife just touches
36
. Tighten four
4
is disengaged after
35
36
9
Advertisement
Table of Contents
