Lights - Yamaha SXV4NP Operator's Manual

Lights

For the correct headlight bulb and/or tail-
light/brake light LED, see the appropriate
specifications sheet.
Removing and Installing
Taillight/Brake Light
These models are equipped with an LED
taillight/brake light. If the LED fails, it
must be replaced.
1. Disconnect the taillight harness con-
nector.
2. Remove the two Torx-head screws
securing the taillight to the bracket.
3. Connect the taillight harness connec-
tor; then secure the taillight to the
bracket with the two Torx-head
screws.
Adjusting Headlight Aim
Mountain Max/Transporter
The headlight can be adjusted for vertical
aim of the HIGH/LOW beam. The LOW
beam is used for vertical aiming.
1. Position the snowmobile on a level
floor so the headlight is approxi-
mately 8 m (25 ft) from an aiming
surface (wall or similar surface).

NOTE: There should be an "aver-
age" operating load on the snowmo-
bile when adjusting headlight aim.
2. Measure the distance from the floor
to midpoint of the headlight.
3. Using the measurement obtained in
step 2, make a horizontal mark on
the aiming surface directly in front
of the headlight.
4. Make a vertical mark which inter-
sects the horizontal mark on the aim-
ing surface directly in front of the
headlight.
44
5. Engage the brake lever lock and start
the engine. Move the headlight dim-
mer switch to the LOW beam posi-
tion. DO NOT USE HIGH BEAM.
6. Observe the headlight beam aim.
Proper aim is when the LOW beam
is centered on the vertical mark 5 cm
(2 in.) below the horizontal mark on
the aiming surface.
7. Adjust the headlight using the adjust-
ing screw on the backside of the head-
746-097B
light using a 4 mm swivel socket and
long extension until correct aim is
obtained. Shut the engine off; then
disengage the brake lever lock.
LED
SXVenom/SXVenom
Mountain/Transporter Lite
The headlight can be adjusted for vertical
aim of the HIGH/LOW beam. The geo-
metric center of LOW beam zone is to be
used for vertical aiming.
1. Position the snowmobile on a level
floor so the headlight is approxi-
mately 8 m (25 ft) from an aiming
surface (wall or similar surface).

NOTE: There should be an "aver-
age" operating load on the snowmo-
bile when adjusting headlight aim.
0753-157Y
ONS-331