Table of Contents
Advertisement
12. Install the battery bracket/solenoid
and tighten the two screws and lock
nuts to 1.2 kg-m (105 in.-lb); install
the seat heater harness (if equipped),
then install the seat and secure with
the
Torx-head
securely.
400
These sealed batteries after being in ser-
vice
require
regular
recharging in order to deliver peak per-
formance and maximum service life. The
following procedures are recommended
for cleaning and maintaining sealed bat-
teries. Always read and follow instruc-
tions provided with battery chargers and
battery products.
NOTE: Battery maintenance may
be done by the snowmobile owner if
qualified to do so. If the owner does
not feel qualified, take the snowmo-
bile to an authorized Yamaha Snow-
mobile dealer for this service. This
service is at the discretion and
expense of the snowmobile owner.
To remove and charge the battery, use the
following procedure:
! WARNING
Improper handling or connecting of a
battery may result in severe injury
including
acid
burns, or blindness as a result of an
explosion. Always remove rings and
watches. Any time service is per-
formed on a battery, the following
must be observed: keep sparks, open
flame, cigarettes, or any other flame
away. Always wear safety glasses.
Protect skin and clothing when han-
dling a battery. When servicing a bat-
tery in an enclosed space, keep the
area well-ventilated.
! WARNING
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to the
state of California to cause cancer
and reproductive harm. Wash hands
after handling.
1. Remove both access panels and the
hood.
30
screw.
Tighten
cleaning
and
burns,
electrical
2. Remove the springs securing the res-
onator and the expansion chamber;
then disconnect the temperature sen-
sor from the main harness. Remove
both the expansion chamber and the
resonator.
3. Remove the negative battery cable
and ground wire; then remove the
positive cable.
4. Remove the screw securing the bat-
tery
hold-down
remove the battery from the snow-
mobile.
! WARNING
Avoid spillage and contact with skin,
eyes, and clothing.
CAUTION
Do not charge the battery while it is in
the snowmobile with the battery ter-
minals connected.
5. Thoroughly wash the battery with soap
and water; then using a wire brush,
clean the battery posts and cable ends
removing
all
Replace damaged cables or cable ends.
ZR-387
ZR-386
bracket;
then
corrosive
buildup.
Advertisement
Table of Contents
