Parkside PDAP 75 A1 Translation Of The Original Instructions page 72

♦ Use the pressure reducer on the compressed air source to set
the optimum working pressure . Note that the maximum working
pressure may not be exceeded . An excessive working pressure
does not mean increased output; it merely increases the air con-
sumption and accelerates appliance wear . Always comply with
the technical information .
NOTE
► Do not apply the polish too often to the same surface as the
particles it contains could damage the finish .
► Mask any plastic components beforehand as these could be
brightened by the polish .
♦ Switch the compressed air polisher on .
♦ Guide the compressed air polisher parallel onto the workpiece .
♦ Move the appliance parallel to and evenly over the surface being
polished .
♦ Do not press down on the compressed air polisher . Pressing
down hard does not increase the working efficiency!
♦ When you are satisfied with the result, release the trigger
switch off the appliance .
♦ When you have finished working, disconnect the appliance from
the compressed air source .
CAUTION!
► Depending on the size and nature of the workpiece, suitable
safety precautions must be taken . Use suitable clamps to pre-
vent the workpiece from slipping .
► In the event of an interruption to the air supply, release the
trigger immediately .
PDAP 75 A1 GB │ MT │ 69
to
■