Husqvarna AUTOMOWER 320 NERA Operator's Manual page 95

• Keep a minimum of 150 cm / 60 in. of free space
to the right and left of the center of the charging
station.
• Put the charging station near a power outlet.
• Put the charging station on a level surface.
• The baseplate of the charging station must not be
bent.
max. 5 cm / 2"
max. 5 cm / 2"
• If the work area has two parts separated with a
steep slope, we recommend to put the charging
station in the lower section.
• Put the charging station in an area with protection
from the sun.
• For Automower ® 320 NERA, put the charging
station where there is Wi-Fi coverage to download
Download firmware over
new firmware. Refer to
the air FOTA (Firmware over the air) on page
101 . For Automower ® 430X/450X NERA this is
recommended, but not necessary.
• If the charging station is installed on an island,
make sure to connect the guide wire to the island.
1910 - 002 - 03.01.2023
36.4.2 To examine where to put the power
supply
CAUTION:
Make sure that the blades
on the product do not cut the low-voltage
cable.
CAUTION:
Do not put the low-voltage
cable in a coil or below the charging station
plate. The coil causes interference with the
signal from the charging station.
• Put the power supply in an area with a roof and
protection from the sun and rain.
• Put the power supply in an area with good airflow.
• Use a residual-current device (RCD) with a tripping
current of maximum 30 mA when you connect the
power supply to the power outlet.
Low-voltage cables of different lengths are available as
accessories.
36.4.3 To examine where to put the
boundary wire
CAUTION:
There must be a barrier of
minimum 15 cm / 6 in. in height between
the boundary wire and water bodies, slopes,
precipices or public roads. This will prevent
damage to the product.
CAUTION:
Do not let the product
operate on gravel.
CAUTION:
Do not make sharp bends
when you install the boundary wire.
CAUTION:
For a careful operation
without noise, isolate all obstacles such as
trees, roots and stones.
The boundary wire must be put as a loop around the
work area. Sensors in the product sense when the
product goes near the boundary wire, and the product
selects a different direction. All parts of the work area
must be maximum 35 m / 115 ft. from the boundary wire.
Installation - 95