Husqvarna AUTOMOWER 320 NERA Operator's Manual page 104

41.2 To put the product into storage
CAUTION:
Charge the battery fully
before you put the product into storage. If
the battery is not fully charged it can cause
damage to the battery.
• Charge the product fully. Refer to
battery on page 102 .
• Set the product to OFF. Refer to
to OFF on page 102 .
• Clean the product. Refer to
• Put the product in a dry, frost-free area.
• Put the product with all wheels on level ground or
use a wall hanger.
• We recommend to put the product in the package
of the product. You can also hang the product on a
Husqvarna wall hanger. Speak to your Husqvarna
representative for more information about available
wall hangers.
41.3 To put the charging station into
storage
You can remove the top of the charging station and put
it into storage. It is not necessary to put the baseplate of
the charging station into storage.
1. Tilt the top of the charging station and open the
hatch.
2. Disconnect the power supply unit from the
charging station and from the power outlet.
3. Disconnect the cable.
4. Remove the grommet with the cables.
5. Pull the top of the charging station up and remove
it.
6. Close the sealing lid.
104 - Transportation, storage and
disposal
To charge the
To set the product
Cleaning on page 102 .
7.
8.
41.4 To install the charging station after
storage
1.
2.
3.
4.
5.
6.
7.
8.
41.5 Disposal
The symbol on the Husqvarna product means that
the product cannot be disposed as usual domestic
waste. Use the local recycling system for electronic
components and batteries. Remove the battery from the
product before you discard the product.
For information about how to remove the battery, refer to
the full Operator's manual on Husqvarna's web site.
Obey the local recycling requirements and applicable
regulations. Speak to local authorities, recycling location
or your Husqvarna dealer for more information.
Close the hatch.
Put the power supply unit and the top of the
charging station in a dry, frost-free area.
Open the hatch.
Push in the sealing lid.
Attach the top of the charging station.
Tilt the top of the charging station.
Put the grommet with the cables into position.
Connect the cable to the charging station.
Connect the power supply unit to the power outlet
and to the charging station.
Close the hatch.
1910 - 002 - 03.01.2023