First Use: Inserting The Sim Card And Battery; Remove The Battery; Getting Started - T&D Ecom x.com 400 Operating Instructions Manual

First use: Inserting the SIM card and battery

u
x.
com 50x -Ex
Version
v

Remove the battery

Proceed as follows in order to remove the battery.
x.
com 50x -Ex / 60x -Ex: Remove the safety lock!
Version
- Turn over the phone. Press on the middle of the cover in the area of the cavity and lift it off.

Getting started

You are now ready to use your phone for the first time.
Switch on the phone by pressing the
phone for the first time, you must configure it with various settings that will remain by default
until you choose to modify them.
After entering your PIN code and the date and time, make your choice for the following settings:
Time zone, Daylight Saving Time, ring tone, volume, vibration alarm and voice mail number. If
there are contacts saved in your SIM card, you can copy them in the phone contacts memory if
desired.
80
Insert the SIM card into the card holder. When doing
u
this make sure that the tapered side of the card is fa-
cing the same way as illustrated in the diagram and/or
the plate on the mobile phone.
x.
com 60x -Ex
Version
Install the battery by first laying down the upper side
v
and then pressing the area of the battery downward.
Version
Set up the safety lock!
key. A short display appears. When you switch on your
x.
com 50x -Ex / 60x -Ex