Connecting Weld Output Cables; Remote 14 Receptacle Rc8 - Miller Deltaweld Series Owner's Manual

5-6. Connecting Weld Output Cables

1
Tools Needed:
3/4 in. (19 mm)
!
Turn off power before connecting to
weld output terminals.
!
Failure to properly connect weld
cables may cause excessive heat
and start a fire, or damage your ma-
chine.
.
Do not place anything between weld

5-7. Remote 14 Receptacle RC8

OM-223 Page 18
.
A complete Parts List is available at www.MillerWelds.com
6
3
4
5
cable terminal and copper bar. Make
sure that the surfaces of the weld cable
terminal and copper bar are clean.
1 Correct Weld Cable Connection
2 Incorrect weld Cable Connection
3 Weld Output Terminal
4 Supplied Weld Output Terminal Nut
A J
K
I
B
C L N
H
M
D G
F
E
2
5 Weld Cable Terminal
6 Copper Bar
Remove supplied nut from weld output ter-
minal. Slide weld cable terminal onto weld
output terminal and secure with nut so that
weld cable terminal is tight against copper
bar.
!
1
Connect feeder to RC8.
1
803 778-B
connecting weld output cables 3−2010
Turn off power before con-
necting to receptacle.
Remote 14 Receptacle RC8
Ref. 800 166-D / Ref. S-0004-A