Aiphone JK-DA Installation Manual page 4

3
MountinG
JK-DA
① Removing the
②
main unit from the
Main unit
mounting frame
Remove the main unit.
(Loosen the locking screws.)
Screwdriver
Tighten Loosen
JK-DV
Vandal-resistant front panel
Loosen
Special
screwdriver
Tighten
JK-DVF
Vandal-resistant front panel
Transparent
nameplate
Special
screwdriver
Tighten Mounting
screws x 4
Place " UP" upwards
1-gang box
Mounting
screws x 2
83.5 mm
(3-5/16")
Mounting frame
Drainage hole
Do not block the holes.
75 mm
Anchor bolts x 4
150 mm
5-15/16''
Ø 6 mm 35 mm
Ø 1/4" 1-3/8"
Drainage hole
Do not block the holes.
Flush mount
back box
110 mm
4-3/8''
180 mm
7-3/32''
45 mm
1-25/32''
- 4 -
③ Mount the main unit on
the mounting frame, and fit
the front panel on.
Front panel Main unit
Using the transparent nameplates
Inserting the transparent nameplates
① Remove the vandal-resistant front panel.
② Peel off the protective seals on the plate (both sides).
3''
③ Fill in the name of the resident on the transparent
nameplate.
Be sure to leave 25 mm (1") of white space on the left end
to account for insertion.
④ Insert the filled-in transparent nameplate at the specified
insertion opening (indicated with
To
insertion
opening
25 mm
1"
Using the transparent nameplates
Inserting the transparent nameplates
① Remove the vandal-resistant front panel from the flush mount back
box.
② Peel off the protective seals on the plate (both sides).
③ Fill in the name of the resident on the transparent nameplate.
Be sure to leave 25 mm (1") of white space on the left end to
account for insertion.
④ Insert the filled-in transparent nameplate at the specified insertion
opening on the rear side of the vandal-resistant front panel (indicated
with in diagram).
25 mm
1"
Removing the front panel
<Bottom surface>
Flathead
screwdriver
Pry off the front panel with
a flathead screwdriver.
in diagram).
To
ABC
insertion
opening
To
ABC
insertion
opening