Setting up and Connecting Your Monitor
special Apple Macintosh adapter to one end of the monitor signal
cable.
Connect the cables to the back of your computer by following these steps:
(a)
Turn off your computer and unplug its power cord.
Connect the monitor signal cable to the video connector on the back of your
(b)
computer.
(c)
Plug the power cord on your computer and your monitor into a nearby outlet.
(d)
USB plug
(1)
cable.
(2)
Turn on your computer and monitor. If the monitor displays an image, installation is
(e)
complete.
Note:
USB 2.0 depends on your PC's specification.
file:///D|/My%20Documents/dfu/230WP7/english/230wp7/install/connect.htm (2 of 2)2006-01-10 3:35:04 PM
If you use an Apple Macintosh
Connect USB upstream port on monitor and the USB port on PC with a USB
The USB downstream port is now ready for any USB device to plug in
The USB plug is a pass through connection whether it can support USB 1.1 or
TM
, you need to connect the
RETURN TO TOP OF THE PAGE