Panasonic KX-TGMA44C Installation Manual page 12

Getting Started
Item
–
Z
In use
Line in use
Registering a handset to a base unit
1
Base unit:
Press and hold MLOCATOR/INTERCOMN for about 5 seconds.
R If all registered handsets start ringing, press MLOCATOR/
2
Handset:
Place the handset on the base unit or charger, then wait until a long
beep sounds and
Note:
R If an error tone sounds, or if
according to the base unit's operating instructions.
12
TGMA44C(en)_0610_ver021.pdf
Meaning
Eco mode is on.
Noise reduction is set.
Tone control level (Tone 1-6 or Custom tone)
Speakerphone is on.
Ringer volume is off.
Night mode is on.
Privacy mode is on.
Alarm is on.
Handset number
Battery level
Blocked call
Answering system is being used by another
handset or the base unit.
Someone is using the line.
INTERCOMN again to stop, then repeat this step.
is displayed.
For assistance, visit www.panasonic.ca/english/support
12
is displayed, register the handset
2016/06/13 10:56:21