Mitsubishi Electric MSZ-SF35VE3 Operating Instructions Manual page 4

● OPERATING INSTRUCTIONS ●
N
AME OF EACH PART
Indoor unit
Front panel
Air fi lter
(Air purifying
fi lter)
Air cleaning fi lter
(Silver-ionized air
purifi er fi lter, option)
Horizontal vane
Heat exchanger
Air outlet
Spec name plate *1
Operation
indicator lamp
Outdoor unit
Outdoor units may be different in appearance.
*1 The manufacturing year and month is indicated on the spec name plate.
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
Installing the remote controller batteries
4.
Press RESET.
1.
Remove the front lid.
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• The battery replacement indicator lights up when the battery is running low.
In about 7 days after the indicator starts lights up, the remote controller stops
working.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
En-3
Air inlet
Emergency
operation
switch
Page 4
Remote control
receiving section
Air inlet (back and side)
Spec name plate *1
Refrigerant piping
Drainage hose
Air outlet
Drain outlet
2.
Insert the negative
pole of AAA
alkaline batteries fi rst.
3.
Install the front lid.
Remote controller
Battery replacement indicator
Page 3
Operation
display section
Temperature
buttons
Page 4
Operation
select button
Page 4
ECONO COOL
button
Page 6
i-save button
Page 6
CLOCK button
Page 3
Remote controller holder
• Install the remote con-
troller holder in a place
where the signal can be
received by the indoor
unit.
• When the remote con-
troller is not used, place
it in this holder.
Setting current time
1.
Press CLOCK.
4.
Press CLOCK again.
• Press CLOCK gently using a thin instrument.
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit
when the signal is
received.
OFF/ON
(stop/operate) button
FAN speed control
button
Page 5
VANE control
button
Page 5
TIME, TIMER set buttons
Pages 3, 6
Increase time
Decrease time
WEEKLY TIMER
set buttons
Pages 3, 7
RESET button
Page 3
Lid
Slide the lid down to open
the remote controller. Slide
it down further to get to the
weekly timer buttons.
Only use the remote controller provid-
ed with the unit.
Do not use other remote controllers.
If two or more indoor units are installed
in proximity to one another, an indoor
unit that is not intended to be operated
may respond to the remote controller.
3.
Press the DAY button
to set the day.
2.
Press either the TIME button or
the TIMER buttons to set the
time.
Each press increases/decreases
the time by 1 minute (10 minutes
when pressed longer).