Fcc Verification - Seagate ST317221A Product Manual

U8 Family Product Manual, Rev. A
comply with the directives when used in the test systems, we cannot
guarantee that all systems will comply with the directives. The drive is
designed for operation inside a properly designed enclosure, with prop-
erly shielded I/O cable (if necessary) and terminators on all unused I/O
ports. Computer manufacturers and system integrators should confirm
EMC compliance and provide CE marking for their products.
Australian CE-Tick (N176)
If these models have the C-Tick marking, they comply with the Australia/
New Zealand Standard AS/NZS3548 1995 and meet the Electromag-
netic Compatibility (EMC) Framework requirements of Australia's Spec-
trum Management Agency (SMA).

1.12.3 FCC verification

These drives are intended to be contained solely within a personal
computer or similar enclosure (not attached as an external device). As
such, each drive is considered to be a subassembly even when it is
individually marketed to the customer. As a subassembly, no Federal
Communications Commission verification or certification of the device is
required.
Seagate Technology, Inc. has tested this device in enclosures as de-
scribed above to ensure that the total assembly (enclosure, disc drive,
motherboard, power supply, etc.) does comply with the limits for a Class
B computing device, pursuant to Subpart J, Part 15 of the FCC rules.
Operation with noncertified assemblies is likely to result in interference
to radio and television reception.
Radio and television interference. This equipment generates and
uses radio frequency energy and if not installed and used in strict
accordance with the manufacturer's instructions, may cause interfer-
ence to radio and television reception.
This equipment is designed to provide reasonable protection against
such interference in a residential installation. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause interference to radio or television, which can
be determined by turning the equipment on and off, you are encouraged
to try one or more of the following corrective measures:
•
Reorient the receiving antenna.
•
Move the device to one side or the other of the radio or TV.
•
Move the device farther away from the radio or TV.
•
Plug the computer into a different outlet so that the receiver and
computer are on different branch outlets.
15