Troubleshooting - Silvercrest SPR 330 A1 Operating Instructions Manual

Troubleshooting

The following table will help you to identify and rectify minor malfunctions. If the
solutions presented below do not resolve the problem, please contact Customer
Service (see section Service).
Fault Cause
The appliance is not
switched on.
The power plug
The appliance
not plugged in.
will not switch
The mains socket is
on.
not supplying any
power.
The appliance is
defective.
The fresh and waste
water tanks
are not fitted properly
in the appliance.
The waste water
The suction
tank
power is too
weak.
The suction opening
u
The dirt filter
blocked.
The spray
t
nozzle is
not discharging The fresh water tank
s
enough water /
cleaning
solution.
Water is The fresh water tank
s
leaking from
the appliance. sealed.
■ 18 │ GB │ IE
Remedy
Make sure that the appliance is properly
connected to the power supply. Press the
On/Off switch
6
is
Insert the power plug
Check the house mains fuse.
Contact the Customer Service department
(see section Service).
Attach the fresh and waste water tanks
s/3
properly to the appliance (see sections Filling
the fresh water tank and Cleaning the waste
water tank).
Empty the waste water tank
3
is full.
Cleaning the waste water tank).
Clean the cleaning attachment and remove the
blockage (see section Cleaning the handle
is blocked.
and cleaning attachment).
a
is Remove the dirt filter
section Cleaning the waste water tank).
Fill up the fresh water tank
is empty.
Filling the fresh water tank).
Take the fresh water tank
is not properly
ance and make sure that the seal is properly af-
fixed (see section Filling the fresh water tank).
2
to turn on the appliance.
6
into the mains socket.
3
(see section
a
and clean it (see
s
(see section
s
out of the appli-
SPR 330 A1
s/3