Download Print this page

Pico Macom TA-36 Installation And Operation Manual page 3

31-36db adjustable sloped uhf-vhf-fm distribution amplifier
Hide thumbs Also See for TA-36:

Advertisement

11. Power Sources: This product should be operated only from the
type of power source indicated on the marking label. If you are
not sure of the type of power supplied to your home, consult your
appliance dealer or local power company.
12. Power-cord Protection: Power-supply cords should be routed
so they are not likely to be walked on or pinched by items placed
upon or against them. Pay particular attention to cords and plugs,
convenience receptacles, and the point where they exit from the
appliance.
13. Lightning: For added protection for this product during a light-
ning storm, or when it is left unattended or unused for long periods
of time, the unit should be disconnected from power source.
14. Power Lines: An outside antenna system should not be located
in the vicinity of overhead power lines, other electric light or power
circuits, where it can fall into such power lines or circuits. When
installing an outside antenna system, extreme care should be
taken to keep from touching such power lines or circuits as contact
with them may be fatal.
15. Overloading: Do not overload wall outlets and extension cords
as this can result in risk of fire or electric shock.
16. Object and Liquid Entry: Never push objects of any kind into
this product through openings as they may touch dangerous volt-
age points or short-out parts that could result in a fire or electric
shock. Never spill liquid of any kind on the product.
17. Servicing: Do not attempt to service this product yourself as
opening or removing covers may expose you to dangerous voltage
or other hazards. Refer all servicing to qualified service personnel.
18. Damage Requiring Service: Unplug this product from the wall
outlet and refer servicing to qualified service personnel under the
following conditions:
a. When the power-supply cord or plug is damaged.
b. If liquid has been spilled, or objects have fallen into the prod-
uct.
c. If the product has been exposed to rain or water.
d. If the product does not operate normally by following the
operating instruction. Adjust only those controls that are cov-
ered by the operating instructions. An improper adjustment
may result in damage and will often require extensive work by a
qualified technician to restore the product to its normal opera-
tion.
e. If the product has been dropped or the cabinet has been
damaged.
f. When the product exhibits a distinct change in perfor-
mance—this indicates a need for service.
19. Replacement Parts: When replacement parts are required, be
sure the service technician has used replacement parts specified
by the manufacturer or have the same characteristics as the origi-
nal parts. Unauthorized substitutes may result in fire, electric shock
or other hazards.
20. Safety Check: Upon completion of any service or repairs to
this product, ask the service technician to perform safety checks
to determine that the product is in proper operating conditions.
21. Outdoor Antenna Grounding: Before attempting to install this prod-
uct, be sure the antenna or cable system is grounded so as to provide
some protection against voltage surges and built-up static charges.
a. Use No.10 AWG (5.3mm) copper, No.8 AWG (8.4mm) aluminum,
No.7 AWG (10mm) copper-clad steel or bronze wire or larger, as
ground wire.
b. Secure antenna lead-in and ground wires to house with stand-off
insulators spaced from 4 feet (1.22m) to 6 feet (1.83m) apart.
c. Mount antenna discharge unit as close as possible to where
lead-in enters house.
d. A driven rod may be used as the grounding electrode where
other types of electrode systems do not exist. Refer to the National
Electrical Code, ANSI/NFPA 70-1984 for information.
e. Use jumper wire not smaller than No.6 AWG (13.3mm) copper or
equivalent, when a separate antenna grounding electrode is used.
NOTE TO THE CATV SYSTEM INSTALLER
THIS REMINDER IS PROVIDED TO CALL THE CATV SYSTEM
INSTALLER'S ATTENTION TO ARTICLE 820-22 OF THE NEC
THAT PROVIDES GUIDELINES FOR PROPER GROUNDING
AND, IN PARTICULAR, SPECIFIES THAT THE CABLE GROUND
SHALL BE CONNECTED TO THE GROUNDING SYSTEM OF
THE BUILDING, AS CLOSE TO THE POINT OF CABLE ENTRY
AS PRACTICAL.
Ph: 800-421-6511
Safeguards
TA-36
www.picodigital.com
3
Rev. 04/13

Advertisement

loading