Ford Expedition 2018 Owner's Manual page 72

E138637
You can use the keypad to:
• Lock or unlock the doors.
• Program and erase user codes.
• Arm and disarm the anti-theft alarm.
Note: You must have an intelligent access
key within 3 ft (1 m) of your vehicle.
You can operate the keypad with the
factory-set five-digit entry code. The code
is on the owner's wallet card in the glove
box and is available from an authorized
dealer. You can also program up to five of
your own five-digit personal entry codes.
Programming a Personal Entry Code
To create your own personal entry code:
1. Enter the factory-set five-digit code.
2. Press 1·2 on the keypad within five
seconds.
3. Enter your personal five-digit code.
You must press each number within
five seconds of each other.
4. Press 1·2 on the keypad to save
personal code 1.
The doors lock then unlock to confirm that
programming was successful.
Expedition (TB8) Canada/United States of America, enUSA, Edition date: 201708, Third-Printing-
Doors and Locks
To program additional personal entry
codes, repeat Steps 1-3, then for Step 4:
•
•
•
•
You may also program a personal entry
code through the information display.
Tips:
•
•
•
Erasing a Personal Code
1.
2. Press and release 1·2 on the keypad
3. Press and hold 1·2 for two seconds.
All personal codes erase and only the
factory-set 5-digit code works.
Anti-Scan Feature
The keypad goes into an anti-scan mode
if you enter the wrong code seven times
(35 consecutive button presses). This
mode disables the keypad for one minute
and the keypad lamp flashes.
The anti-scan feature turns off after:
•
•
•
Displaying the Factory Set Code
Note: You need to have two programmed
keys for this procedure.
69
Press 3·4 to save personal code 2
Press 5·6 to save personal code 3
Press 7·8 to save personal code 4
Press 9·0 to save personal code 5.
Do not set a code that uses five of the
same number.
Do not use five numbers in sequential
order.
The factory-set code works even if you
have set your own personal code.
Enter the factory-set 5-digit code.
within five seconds.
You must do this within five seconds
of completing Step 2.
One minute of keypad inactivity.
Pressing the unlock button on the
remote control.
Switching the ignition on.