Update Of Mac Address; Imager Dra Data - Sony DSC-RX10M4 Service Manual

Hide thumbs Also See for DSC-RX10M4:

Table of Contents

2-2-5.

Update of MAC Address

When a board that contains Wi-Fi has been replaced or when replacing a board that contains the main IC (CPU), the

IC's unique number (MAC address) must be reloaded.

Procedure of the MAC address update:

Note

Perform the below operations after all work has been done.

Start the Adjust Manual in the Adjust Station and execute the "Wireless LAN Setting (MAC Address)" on

the ADJUST tab.

Operate the unit to initialize of SSID/PW.

Applicable parts:

• SY-1082 BOARD, COMPLETE (SERVICE)

Note

After the replacement and repair, the MAC address is changed, and thus the re-setting for connection devices is required.

Accordingly, download the Flyer of WLAN Reset (Flyer of WLAN Reset_9834752[][].pdf) and print out it, and attach

it to the set when returning the set to customer.

2-2-6.

When you replace to the SY repairing board, get the imager DRA data from the former SY board beforehand. After

replacing the SY board, perform "Imager DRA Data Write" on the Adjust manual to write the imager DRA data gotten.

Note

In the following cases, perform the "Imager DRA EBC Adj" and "Imager SF2 adj" on the Adjust Manual, and write the

imager DRA data.

• When you cannot get the imager DRA data from the unit before replacing the SY board

• When replacing the lens or the imager unit

SF2 adjustment charts (J-6082-839-A and J-6082-856-A) are required in "Imager DRA SF2 adj".

DSC-RX10M4

2-4

Table of Contents