To Set The Event Time; To Start Timing At The Beginning Of An Event - Casio 3556 EN User Manual

To set the event time

To start timing at the beginning of an event

When the current time in the lower display reaches the event start time, press D to
start timing.
• This will display elapsed time measurement in the upper and lower displays.
1. In the Stopwatch Mode, hold down A until the current
event time setting starts to flash in the lower display.
This is the setting screen.
• If the current event time is not displayed, use the
procedure under "To reset elapsed time measurement
to zero" (page EN-18) to display it.
2. While a setting is flashing, use D (+) and B (–) to
change it.
• You can set the event time in the range of 1 minute to
60 minutes, in 1-minute units.
• "- -" indicates there is no event time set.
3. Press A to exit the setting screen.
EN-17