Troubleshooting - Magnavox MDV560VR User Manual

36 Troubleshooting (Continued)
Symptom
Some channels are
skipped over when using
.
3/4
Picture and sound of
broadcasting channel are
weak or missing.
Camcorder image is not
shown.
Camcorder image via A/V
input to DVD+VCR is not
shown on TV screen.
Timer recording is not
possible.
indicator appears after
DVD+VCR is turned off.
Stereo Audio Record
and/or Playback is not
present.
The "PROGRESSIVE
SCAN MODE" message
remains on-screen.
Moisture condensation can occur:
• When the DVD+VCR is moved from a cold place to a
warm place.
• Under extremely humid conditions.
Cause
" "
Those channels were deleted with the
CH. ADD/DEL option.
" "
Antenna or cables are loose.
" "
Wrong TUNING BAND option is being
used.
" " Camcorder is off. Ensure playback tape is
loaded properly.
" " DVD+VCR SOURCE SELECT is not set to
LINE1 or LINE2.
" " Clock in DVD+VCR is not set to correct
time.
" " Timer has been programmed
incorrectly.
" " indicator does not appear on
DVD+VCR after programming timer.
" " DVD+VCR is in Timer Recording mode.
" " TV is not Stereo-compatible.
" " Broadcast program is not in stereo format.
" " DVD+VCR A/V Out jacks are not con-
nected to TV A/V In jacks.
" "
DVD+VCR Audio/Video Out is not select-
ed for viewing at the TV.
" " DVD+VCR BROADCAST TYPE mode is
set to SAP or MONO.
" " DVD+VCR was turned 'ON' while setting
the Progressive scan mode.
Moisture Condensation
" "
Use CH. ADD/DEL. to restore channels.
See "Channel Selection" on page 15.
" " Tighten connections or replace cable.
" " Try all TUNING BAND options. See
"Channel Selection" on page 15 for details.
" " Turn camcorder on and press PLAY to
operate properly. Re-check connections.
" "
Press INPUT to select LINE input channel
(LINE1 or LINE2).
" "
Set clock to correct time. See "Setting the
Clock" on page 16.
" " Reprogram Timer. See "Timer Recording"
on pages 22 and 23.
" "
Reprogram Timer.
" "
This is the normal indication that the
DVD+VCR is in TIMER mode.
" " No action is possible.
" " No action is possible.
" "
Make A/V connections. Stereo is
available only via A/V output from
DVD+VCR.
" " Select AUX or A/V source as TV input.
" " Set BROADCAST TYPE mode to
STEREO. See "Setting the VCR Setup
Menu" on page 15.
" " Press and hold the STOP button for more
than 5 seconds to cancel Progressive mode
setting.
In locations where moisture condensation may occur:
• Keep the DVD+VCR plugged into an AC power outlet
with POWER On. This will help prevent condensation.
• When condensation has occurred, wait a few hours for
the DVD+VCR to dry before using it.
Correction