Setting The Com Port Buffers; Specifying Measurement Units; Installing The Rrm Software For Foundation Fieldbus - Emerson Rosemount 5402 Reference Manual

Reference Manual
00809-0100-4026, Rev KC
5.4.5

Setting the COM port buffers

The COM port Receive Buffer and Transmit Buffer need to be set to 1 by doing the following:
1. In the Microsoft
2. Select the Hardware tab and select the Device Manager button.
3. Expand the Ports node in the tree view.
4. Right click the selected COM port and then select Properties.
5. Select the Port Settings tab and select the Advanced button.
6. Drag the Receive Buffer and Transmit Buffer slides to 1.
7. Select the OK button.
8. Reboot the computer.
5.4.6

Specifying measurement units

Measurement units for data presentation in RRM can be specified when the RRM program is installed.
Units can also be changed as follows:
1. Select the Application Preferences option from the View menu.
2. Select the Measurement Units tab.
3. Select the desired units for Length, Level Rate, Volume, and Temperature.
5.4.7 Installing the RRM software for F
To install the RRM for F
1. Start by installing the National Instruments Communication Manager software. See National
Instruments manual (Getting started with your PCMCIA-FBUS and the NI-FBUS™ software) for more
information.
2. Insert the RRM installation CD into your CD-ROM drive.
3. If the installation program is not automatically started, select Run from the Windows Start bar.
4. Type D:\RRM\Setup.exe where D is the CD-ROM drive.
5. Follow the instructions on the screen.
6. Make sure that F
Configuration
®
Windows Control Panel, open the System option.
Fieldbus communication:
OUNDATION
Fieldbus is selected as default protocol.
OUNDATION
Fieldbus
OUNDATION
Configuration
October 2018
113