Cadillac CT4 2023 Owner's Manual page 78

INT : Use this setting for intermittent wipes
or for Rainsense wipes, when Rainsense is
enabled. For intermittent wipes, move the
lever up to INT, then turn the
for more frequent wipes or down for less
frequent wipes. If Rainsense is enabled, see
Rainsense later in this section.
If the windshield wipers are in use while
driving, the exterior lamps come on
automatically if the exterior lamp control is
in AUTO. The transition time for the lamps
coming on varies based on wiper speed. See
Lights On with Wipers under Automatic
Headlamp System 0 116.
OFF : Use to turn the wipers off.
1X : For a single wipe, briefly move the
wiper lever down. For several wipes, hold
the wiper lever down.
Clear snow and ice from the wiper blades
and windshield before using them. If frozen
to the windshield, carefully loosen or thaw
them. Damaged blades should be replaced.
See Wiper Blade Replacement 0 310.
Heavy snow or ice can overload the wiper
motor.
band up
In freezing weather, do not use the
washer until the windshield is warmed.
Otherwise the washer fluid can form ice
on the windshield, blocking your vision.
Before driving the vehicle, always clear
snow and ice from the hood, windshield,
washer nozzles, roof, and rear of the
vehicle, including all lamps and windows.
Reduced visibility from snow and ice
buildup could lead to a crash.
Wiper Parking
If the ignition is turned off while the wipers
are on LO, HI, or INT with Rainsense
disabled, they will immediately stop.
Warning
Warning
Instruments and Controls
If the windshield wiper lever is then moved
to OFF before the driver door is opened or
within 10 minutes, the wipers will restart
and move to the base of the windshield.
If the ignition is turned off while the wipers
are performing wipes due to windshield
washing or Rainsense, the wipers continue
to run until they reach the base of the
windshield.
Rainsense
If equipped with Rainsense, a sensor near
the top center of the windshield detects the
amount of water on the windshield and
controls the frequency of the windshield
wiper.
To turn the Rainsense feature on or off,
select Settings > Vehicle > Comfort and
Convenience > Rainsense Wipers > Select ON
or OFF.
Keep this area of the windshield clear of
debris to allow for best system performance.
AUTO : When enabled, move the windshield
wiper lever to AUTO. Turn the
the wiper lever to adjust the sensitivity.
77
band on