Epson L355 Start Here

Start Here
EN
© 2013 Seiko Epson Corporation. All rights reserved.
Read This First
This product requires careful handling of ink. Ink may splatter when the ink tanks are filled or refilled with ink. If ink gets on your clothes or belongings, it may not
come off.
1
Unpacking
Do not open the initial setup ink bottle package or the refill ink bottle package until you are ready to fill the
ink tank. The ink bottle is vacuum packed to maintain its reliability.
For initial setup
2
Filling Ink
The illustrations in this guide may
differ from your actual product.
Check position.
Connect and plug in. Turn on.
3
Connecting to the Computer
Do not connect the USB cable until you are instructed to do so.
If the Firewall alert appears, allow access for Epson applications.
Windows
Mac
Insert.
A
Windows
Select and follow the instructions.
Windows 7/Vista: AutoPlay
window.
Important; must be observed to avoid damage to your equipment.
Remove all protective materials.
Do not pull the tubes.
Unhook.
Press for 3 seconds until starts Charging ink takes about 20 minutes.
flashing. Charging ink is started. Wait until the light turns on.
Windows
Mac
Check and proceed.
B
Mac
Select and follow the instructions.
Only the software with a selected check box is installed. Epson Online Guides
contain important information such as troubleshooting. Install them if necessary.
Use the ink bottles that came with your product.
Even if some ink bottles are dented, the quality and quantity of ink are guaranteed, and they can be used safely.
Epson cannot guarantee the quality or reliability of non-genuine ink. The use of non-genuine ink may cause damage that is not covered by Epson's
warranties.
Open and remove. Snap off, remove, and then install.
.
Install.
Install securely.
Before printing, be sure to hook the ink tank unit onto the product. Do not lay
the ink tank unit down, or position the unit higher or lower than the product.
Hook onto.
Loading Paper and Copying
Do not load paper above mark inside the edge guide.
Load paper with its printable side face up.
Transporting
A
B
Secure print head. Set transportation lock.
Keep the product level as you transport it. Otherwise, ink
may leak.
Be sure to keep the ink bottle upright when tightening
the cap, and take measures to prevent ink from leaking
as you transport it.
Install the ink bottle cap tightly;
otherwise ink may leak.
Match the ink color with the tank, and
then fill with
Repeat steps to for each ink bottle. Close.
Loading Capacity (sheets) for copying
Plain Paper 11 mm
Bright White Ink Jet Paper
Install securely. Make sure to hook on.
After you move it, remove the tape securing the Store the covers at the side of the
print head and the covers of ink tanks, then set the product.
transportation lock to the unlocked position. If you
notice a decline in print quality, run a cleaning cycle or
align the print head.
all of the ink.
A4
80
Without ink bottles, set in
original or similar box.