Table of Contents
Advertisement
7. Step 7 Mode
Press "MEMORY" key during step 6 operation to display
automatically adjusted values on LCD in the order as
below. Item names are displayed by left alignment, and
adjusted values by right alignment in hexadecimal
numbers. Operations other than display are as same as
those for step 5.
a) "Fb" is displayed on the left of LCD.
command (D480) is transmitted to designate focus
balance adjusting register. Then data read by read
command SRC2 (2) are displayed in hexadecimal
numbers.
After waiting 2 seconds, operation is
shifted to (b).
b) "FG" is displayed on the left of LCD.
command (D481) is transmitted to designate focus
gain adjusting register. Then data read by read
command SRC2 (2) are displayed in hexadecimal
numbers. The upper two bits, which are invalid, are
displayed as "00".
operation is shifted to (c).
c) "Tb" is displayed on the left of LCD.
command (D482) is transmitted to designate tracking
balance adjusting register. Then data read by read
command SRC2 (2) are displayed in hexadecimal
numbers.
After waiting 2 seconds, operation is
shifted to (d).
d) "TG" is displayed on the left of LCD.
command (D483) is transmitted to designate tracking
gain adjusting register. Then data read by read
command SRC2 (2) are displayed in hexadecimal
numbers. The upper two bits, which are invalid, are
displayed as "00". After waiting 2 seconds, operation
is shifted to (e).
e) "FO" is displayed on the left of LCD.
command (D484) is transmitted to designate focus
offset adjusting register. Then data read by read
command SRC2 (2) are displayed in hexadecimal
numbers.
After waiting 2 seconds, operation is
shifted to (f).
f) "TO" is displayed on the left of LCD.
command (D485) is transmitted to designate tracking
offset adjusting register. Then data read by read
command SRC2 (2) are displayed in hexadecimal
numbers.
After waiting 2 seconds, operation is
shifted to (g).
g) "FF" is displayed on the left of LCD.
command (D486) is transmitted to designate RF
amplitude adjusting register. Then data read by read
command SRC2 (2) are displayed in hexadecimal
numbers.
After waiting 2 seconds, operation is
shifted to (a).
FTBAST
FTBAST
After waiting two seconds,
FTBAST
FTBAST
FTBAST
FTBAST
FTBAST
Press the following buttons in this state to obtain the
operations specified below.
"POWER" ................. Test mode and power turned off to
"FF/FWD" ................. The pickup slides toward the outer
"REW/REV" .............. The pickup slides toward the inner
"PLAY" ..................... Invalid
"STOP" ..................... Return to step 1
"FUNCTION" ............ Shift to step 6
"MEMORY" .............. Shift to step 5
*If the focus is not received, the process returns to step 1.
– 17 –
XL-3000W
shift to the ordinary standby mode.
periphery while this button is pressed.
periphery while this button is pressed.
If PICKUP IN is on, input is invalid.
Advertisement
Table of Contents
