Table of Contents
Advertisement
XL-3000W
5. Step 5 Mode
When the CD initialization operation flow is completed,
the mute is turned off, and playback is started. Even if
playback reaches the outermost periphery of disc, the
operation does not stop. The LCD display indicates the
playback passage time as in case of ordinary CD
playback.
Press the following buttons in this state to obtain the
operations specified below.
"POWER" ................. Test mode and power turned off to
shift to the ordinary standby mode.
"FF/FWD" ................. The pickup slides toward the outer
periphery while this button is pressed.
"REW/REV" .............. The pickup slides toward the inner
periphery while this button is pressed.
If PICKUP IN is on, input is invalid.
"PLAY" ..................... Invalid
"STOP" ..................... Return to step 1
"FUNCTION" ............ Shift to step 6
"MEMORY" .............. Shift to step 7
*If the is not received, the process returns to step 1.
Other cautions
• TOC IL is not available for this test mode.
6. Step 6 Mode
Press the FUNCTION button during step 5 operation to
set EC/FC bit to "H" by PRESET command (9188
transmission) and to monitor BUS2 (QDRE) during idle
mode. The number of errors for 1 frame (1 sub-code
block in IC data) is read by read command SRC6 during
"H". The number of errors accumulated in 750 frames for
10 seconds is displayed on LCD. During the display,
music signal is played back.
Press the following buttons in this state to obtain the
operations specified below.
"POWER" ................. Test mode and power turned off to
"FF/FWD" ................. The pickup slides toward the outer
"REW/REV" .............. The pickup slides toward the inner
"PLAY" ..................... Invalid
"STOP" ..................... Return to step 1
"FUNCTION" ............ Shift to step 5
"MEMORY" .............. Shift to step 7
Press FF/PRESET UP or REW/PRESET DOWN button to
slide the pickup. The number of errors accumulated up to
that time is cleared and addition is restarted after shift.
*If the focus is not received, the process returns to step 1.
– 16 –
shift to the ordinary standby mode.
periphery while this button is pressed.
periphery while this button is pressed.
If PICKUP IN is on, input is invalid.
Advertisement
Table of Contents
