Installing The Led Board - Dell P104F Service Manual
Hide thumbs
Also See for P104F:
- Service manual (147 pages) ,
- Technical manualbook (57 pages) ,
- Setup and specifications (33 pages)
Table of Contents
Advertisement
Steps
1. Open the latch and disconnect the smart-card reader cable from the connector on the USH-daughter board.
2. Remove the smart-card reader cable away from the USH-daughter board.
3. Disconnect the LED-board cable from the connector on the system board and unroute the cable.
4. Remove the (M2x3) screw that secures the LED board to the palm-rest assembly.
5. Lift the LED board along with the cable away from the palm-rest assembly.
Installing the LED board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the LED board and provides a visual representation of the installation procedure.
50
Removing and installing components
Advertisement
Table of Contents
