Table of Contents
Advertisement
Solution 6000-IP
User Guide
The keypad will display the following when the
output is on:
External Siren Op1
Output is ON,
To turn OFF, Press OFF.
To Go Back Press OK
To turn the output off, press [OFF].
4. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Outputs > Commands >
Output Array
This menu allows master users to view the status of outputs
on the system in groups of 16. Outputs are continuously
being updated while the array is being displayed so that
real time status can be seen. The top two rows of the
display show the output number when read vertically and
the third row displays the output's status as per below list.
N = NORMAL - Off Condition
T = TRIGGERED - On Condition
F = FAULT - Overload Condition
- = DISABLED
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [0] + [2] and use the up and
down arrows to select the output group to view.
2. Use the up and down arrows at any time to move to
a new group. The keypad will display the following
output array information for outputs 1 to 16.
0000000001111111
1234567890123456
NNNNN---TF------
Press
In the above example screen,
N = Outputs 01 to 05 are Normal (Off )
F = Output 10 has a Fault (Overload)
T = Output 09 is Triggered (On)
- = Outputs 05 to 08 and Outputs 11 to 16 are
Disabled or Not Available
3. Press the [] key and the keypad will display the
output array information for outputs 17 to 32.
1112222222222333
7890123456789012
----------------
Press
4. Use the [] and [] keys to move up and down
the output array and when finished press [OK] or
[MENU] to exit.
26
MENU 4-0-2
OK or MENU
OK or MENU
Outputs > Commands >
Door Status
This menu allows the master user to view the status of a
selected door.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [0] + [3].
A list of available doors will display on the keypad.
Dr1 Front Door
Dr2 Computer Room
Dr3 Warehouse Door
Press
2. Use the [] and [] keys to select the door that you
want to check the status of, then press [OK] to select.
Alternatively, you can enter the door number then
press [OK].
The keypad will display the following:
Front Door Dr1
Locked
<Door Related Information>
Press OK or MENU
3. The following door states can be displayed in the
door status menu.
Locked
Unlocked
Unlocked by TimeZone
Open
Forced Open
Open Too Long
Unlocked - Fire
4. When finished press [OK] or [MENU] to exit.
Outputs > Commands >
Door Array
This menu allows the master user to view the status of
doors on the system. Up to 16 doors are supported on this
system. Doors will continuously be updated during the
display so that real time status can be seen. The top two
rows of the display show the door number, the third row
displays the door status
L = Door Locked
U = Door Unlocked
O = Open
- = Disabled or Not Available
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [0] + [4]. The keypad will
Bosch Security Systems 10/22 BLCC615U
MENU 4-0-3
OK or MENU
MENU 4-0-4
Advertisement
Table of Contents
