Table of Contents
Advertisement
English
12.2
Sawing
WARNING
■ If kickback occurs, the chainsaw can be
thrown up in the direction of the operator. This
may result in serious or fatal injury to the user.
► Always cut with the chain running at full
speed.
► Do not cut with the upper quadrant of the
guide bar nose.
► Begin the cut with the chain running at full
speed and keep the guide bar vertical.
► Engage the spiked bumper and use it as a ful‐
crum.
► Guide the full width of the guide bar into the
wood and reposition the spiked bumper as
required.
► Pick up the weight of the chainsaw at the end
of the cut.
For optimum performance, observe the recom‐
mended temperature ranges,
12.3
Delimbing
► Support the chainsaw on the log.
► With the chain running at full speed, pivot the
guide bar downward against the limb.
► Cut through the limb with the top of the guide
bar.
20
► If the limb is under tension: Make the relieving
12.4
12.4.1
► Determine direction of fall so that the area in
► Observe the following points when planning
20.8.
12.4.2
► Remove obstacles from work area at tree
► Remove growth from tree base.
► If the tree has large, healthy buttress roots:
1
2
cut (1) into the compression side and then per‐
form the bucking cut (2) from the tension side.
Felling
Determining direction of fall and
escape path
which the tree falls is clear.
escape path (B):
– Escape path (B) at an angle of 45° to direc‐
tion of fall (A).
– No obstacles on the escape path (B).
– The top of the tree can be observed.
– If the escape path (B) is on a slope, it must
be parallel to the slope.
Preparing work area at base of tree
base.
Make vertical cut first and then a horizontal
cut, and remove the resulting piece.
12 Operating the Saw
2
1
0458-022-8301-A
Advertisement
Table of Contents
