Advertisement
12. Apply pipe sealant and screw the TDC sensor
(25b*) into the gear housing. Torque to 66-78 in-lb
(7.4-8.8 N•m).
TDC sensor nuts are locked in place to ensure cor-
rect positioning. Do not adjust.
13. Install the circuit board (25c) using four screws
(12*).
14. Reconnect the TDC cable (25b*) to J2 on the circuit
board (25c).
11
Torque to 66-78 in-lb (7.4-8.8 N•m).
25c
F
. 1. TDC Sensor Kit
IG
311601A
25b*
12
11
33*
34
ti8725a
15. Reconnect the transducer cable (25a) to J1 on the
circuit board (25c).
16. Reconnect the IS circuit field wire to J2 and J3. See
the Electrical Schematic in the E-Flo Plus
Repair-Parts manual 311594.
17. Install the new gasket (33*), the circuit board cover
(34), and six screws (12*).
18. Reinstall the cover (32) with two screws (12*).
25c
25b*
25a
Kit Installation
3
Advertisement
