Grundig 43 GDU 7810B Manual page 143

NETWORK SETUP
7 Press »EXIT« to end the setting.
Note:
If you do not have a dynamic network,
7
follow the instructions in manual connection
section.
Television / User Manual
-------------------------------------------------------------------------------------------
Manual connection
Certain networks require Static IP address. If
your network requires a Static IP address, you
must enter the »IP Address«, »Netmask«, »Gate-
way« and »DNS« values manually. You can
get »IP Adresi«, »Netmask«, »Gateway« and
»DNS« values (ISS) from your Internet Service
Provider.
1 Open the menu with »MENU«.
2 Press »
press »
3 Press »
work« and press »OK« to confirm.
4 To approve the Privacy Policy, press »
>
» « to select »Accept« and press »OK« to
confirm.
5 According to your network infrastructure,
press »
»IPv6« and press »OK« to confirm.
Note:
To access the internet through IPv6, your
7
internet service provider and modem must
support IPv6. If only the modem supports
IPv6, it can only connect to the modem; you
cannot connect to internet.
6 Press »
and press »OK« to confirm.
– »IP Address«, »Subnetwork«, »Gateway«
and »DNS« options are enabled.
7 From the »IP Address« line, use »1...0« to
enter the IP address.
8 From the »Subnetwork« line, use »1...0« to
enter the Subnetwork address.
9 From the »Gateway« line, use »1...0« to
enter the Gateway address.
10 From the »DNS1« line, use »1...0« to enter
the DNS1 address.
11 From the »DNS2« line, use »1...0« to enter
the DNS2 address.
12 To complete the setting process, press »OK«
to confirm.
13 Press »EXIT« to end the setting.
« or » « to select »Network« and
V Λ
>
« to confirm.
« or » « to select »Wired Net-
V Λ
« or » « to select »IPv4« or
V Λ
« or » « to select »Manual Input«
V Λ
<
« or
61 / 81 EN