Beaching; Anchoring - Yamaha 210 FSH 2019 Operator's Manual

Operation
Wind or current
Wind or current pushing boat toward
dock:
Slowly maneuver to a shallow angle and al-
low the boat to move toward the dock.
Wind or current
No wind or current:
Approach the dock at a shallow angle. Se-
cure the bow to the dock, and then use en-
gine thrust or a boat hook to gently move the
stern to the dock.

Beaching

NOTICE
 Small pebbles, sand, seaweed, and oth-
er debris can be sucked into the jet in-
takes and impair or damage the
impellers. Always stop the engines be-
fore beaching the boat. Be sure the boat
is in water 90 cm (3 ft) deep from the
bottom of the boat before starting the
engines again.
102
Do not beach the boat on rocky beach-

es. The hull gelcoat and exposed pump
housings can be damaged.
 Pay attention to shifts in tides. Beaching
at high tide may make it impossible to
re-launch the boat if the tide recedes.
(1) Make sure no obstructions, boats, or
swimmers are near the beach.
(2) Approach the beach slowly and stop the
engines when the water is about 90 cm
(3 ft) deep from the bottom of the boat.
Remember: turning is impossible with
the engines stopped.
(3) Get out of the boat and pull the bow up
on the beach.
(4) When leaving the beach, push the boat
out into water that is at least 90 cm (3 ft)
deep from the bottom of the boat before
starting the engines.

Anchoring

WARNING
Always anchor from the bow. Anchoring
from the stern will make the boat un-
steady. A strong current can pull a stern-
anchored boat underwater.
Select an anchor appropriate for your boat
and water conditions. A "Danforth" (or fluke)
type anchor is suitable for most applications;
your Yamaha Boat Dealer can help you
choose an anchor.
(1) Make sure the anchor line is securely tied
to the anchor and to the bow eye or a
bow cleat.
(2) Move the boat to the spot where you
want to lower the anchor, heading the
boat into the wind or current. Stop the
boat, and then lower the anchor until it
hits bottom.