Table of Contents
Advertisement
9.21. Remove the Plasma panel sec-
tion from the Cabinet assy
1. Place the Cabinet assy on a flat surface of a table (cov-
ered by a soft cloth) and a cushion.
2. Remove the Contact metal bottom B. (See section 9.20.)
3. Remove the screws (×11
4. Remove the Plasma panel section from the Cabinet assy.
).
9.22. Remove the Contact metals
1. Remove the Cabinet assy. (See section 9.21.)
2. Remove the Tape from the Contact metals.
3. Remove the screws (×12
4. Remove the Contact metal side (L, R).
5. Remove the screws (×6
6. Remove the Contact metal top.
9.23. Remove the K-Board
1. Remove the Contact metal bottom B. (See section 9.20.)
2. Remove the screws (×2
3. Remove the claw (×1
4. Disconnect the connector (K1) and remove the K-Board
from the LED Panel.
9.24. Remove the V-Board
1. Remove the Contact metal bottom B. (See section 9.20.)
2. Remove the Claw (×1
3. Disconnect the connector (V14) and remove the V-Board
from the 3D emitter panel.
27
).
).
).
).
).
Advertisement
Table of Contents
