Setting The Alarm Disabling Duration (Alarm Disable); D Setting The Motion Sensor (Motion); Setting The Motion Zone - Sanyo VCC-9500P Instruction Manual

Alarm Settings (ALARM)
Setting the alarm disabling duration
C
(ALARM DISABLE)
The Alarm Disable function allows the alarm input to be ignored
for the specified duration during manual pan/tilt/zoom
operations and after manual operation.
ALARM
ALARM IN
ALARM OUT
ALARM DISABLE
TIME
MOTION
ALARM DISPLAY
PRESET
MENU
1
Use the joystick lever (xy) to select [ALARM
DISABLE], use the lever (vw) to select "ON/OFF",
and press the [ENTER] button.
Available settings:
• OFF: Disables the Alarm Disable function.
• ON: Enables the Alarm Disable function. ([TIME] appears
under [ALARM DISABLE].)
The Alarm Disable function can also be turned on
or off through the AUX8 connection.
2
When "ON" is selected, use the joystick lever (xy)
to select [TIME] and use the lever (vw) to select a
duration for which the alarm input is ignored.
Available settings: 1M, 2M, 3M, 4M, 5M, 6M, 7M, 8M, 9M,
10M (M: Minute)
☞
After completing setting, use the lever to move the cursor to
[MENU] and select "BACK" or "END".
41
1 y
1 y
ON
2M
OFF
OFF
OFF
BACK

D Setting the motion sensor (MOTION)

The built-in motion sensor can be used to detect movements in
the target object such as an intruder.
ALARM
ALARM IN
ALARM OUT
ALARM DISABLE
MOTION
ALARM DISPLAY
PRESET
MENU
Use the joystick lever (xy) to select [MOTION] and use
the lever (vw) to select the motion sensor used for alarm
detection.
Available settings:
• OFF: Does not use the motion sensor.
• ZONE: Uses the sensor specified for the motion zone. (The
MOTION ZONE screen appears.)
• PRESET: Uses the motion sensor selected in [MOTION] of the
[CAMERA VIEW] settings.
Memo: For the "PRESET" option, the movement is detected only at
the preset position: for the [ZONE] option, the movement is
detected for the area specified from whole space where
pan/tilt operations can be performed.
b Setting the motion zone
The Motion Zone function allows you to specify up to four surveillance
areas (AREA 1 - 4) to detect movement.
Setting the surveillance area (AREA) and the detection
option
To set the surveillance area and the detection option, perform the
following procedure in the MOTION ZONE screen.
1
Use the joystick lever (xy) to select [MOTION], use
the lever (vw) to select "ZONE", and press the
[ENTER] button.
The MOTION ZONE screen appears.
MOTION ZONE
AREA 1
AREA 2
AREA 3
AREA 4
SENSITIVITY
ALARM OUT
LINE OUT
DURATION
2
Use the joystick lever (xy) to select [AREA (1 - 4)],
use the lever (vw) to select "ON y", and press the
[ENTER] button.
The AREA setting menu appears.
AREA 1
POSITION
DISPLAY
1 y
1
y
OFF
OFF
OFF
OFF
BACK
OFF
OFF
OFF
OFF
SET y
OFF
OFF
5S
SET y
OFF