Network Failure - Sanyo VCC-HD4600P User Manual

Click RECORDING button in the configuration menu to display the RECORDING screen.
Configure the recording conditions on this screen if you intend to record video on a SD memory card installed in
the camera or an external hard disk drives.
Required operation privilege: admin, operator1
1
In [RECORD STREAM], select the stream you want to record for each recording mode.
Based on the [RECORDING] settings on the VIDEO & AUDIO SETTINGS screen, the selectable stream is
displayed for each recording mode.
The pull-down menu displays the image conditions of the selected stream.
OFF (no recording), STREAM1, STREAM2, STREAM3, STREAM4
NORMAL:
Normal live video is recorded.
Configure the recording time on the SCHEDULE SETTINGS screen.
ALARM:
Alarm video is recorded.
Configure the recording conditions in [ALARM EVENT1] to [ALARM EVENT4] (step

NETWORK FAILURE:

If a network failure occurs during network recording, backup recording is performed until the failure is resolved.
In [NETWORK FAILURE TIME], select the time from the occurrence of a network failure until the camera
recognizes it as a recording trigger.
15SEC, 20SEC, 30SEC, 40SEC, 50SEC, 1MIN, 2MIN, 3MIN, 4MIN, 5MIN
The setting values are interlocked among RECORDING, E-MAIL SETTINGS, and FTP SETTINGS
screens. (Note that the setting configured most recently will take precedence.)
2
To simultaneously record the video and sound, set [AUDIO] to "ON".
3
To detect tampered images, set [ALTERATION DETECTION] to "ON".
4
Configure recording conditions for [ALARM EVENT1].
You can configure four patterns of recording conditions (for ALARM EVENT1 to ALARM EVENT4) and use the
optimal pattern depending on the monitoring purpose of the camera.
4
).
Working with Administrator Configuration Screens 51/71