Table of Contents
Advertisement
STEP 3. ADJUSTING THE DOOR SPRINGS
5.
Replace the back end of the spring by holding the
spring at a right angle to the side of the dishwasher
and pushing the end of the spring into the hole, then
turning the spring in towards the dishwasher.
6.
Reattach the front end of the spring by pulling it up
and forward to fasten it in the mount.
7.
Open the door and check the spring tension again.
If necessary, make further adjustments as above.
XXL DISHWASHERS
The machine is delivered from the factory with two
blue door springs that are designed to accommodate
a door panel that weighs up to 15 lbs. For panels
that weigh between 15 and 19 lbs, remove one blue
spring that came with the unit and replace it with
a green (8079660) spring. For panels that weigh
between 19 and 23 lbs, remove both springs that
came with the unit and replace them with two green
(8079660) springs.
TYPE B
1.
Check that the door is balanced. It should not fall
open or snap shut. Adjust as necessary.
2.
If you need to adjust the door spring tension, use
a screwdriver to turn the hexagonal headed screw
located at the front of the machine.
The maxium weight for the door panel on units with
this type of springs is 19 lbs. Heavier springs are not
available for this unit.
Page 12
ADA DISHWASHERS
The machine is delivered from the factory with one
red, and one blue door spring that are designed to
accommodate a panel that weighs up to 17 lbs. For
panels that weigh between 18 and 22 lbs, remove
the red spring that came with the unit and replace it
with a blue (8088593) spring. For panels that weigh
between 22 and 27 lbs, remove both springs that
came with the unit and replace them with two green
(8079660) springs.
XL = 3-11 kg
XXL = 1-9 kg
Customer Care Center
1-800-898-1879
www.askousa.com
5
6
Nm
Nm
Advertisement
Table of Contents
