Table of Contents
Advertisement
MENU
Advanced Menu
Item
PIN LOCK
PROTECTION
MODIFY PIN
ViewSonic
Selection
OFF: Turn off PIN lock protection.
ON 1: P IN code is needed only in the first time after AC
ON 2: PIN code is needed every time while the projector
OFF
ON 1
ON 2
Once the PIN code had been set, the projector cannot
be used unless you enter the correct PIN code.
1. Press " MENU " on the projector or remote control.
2. U se the ► button to select the MODIFY PIN item of the
SECURITY category.
3. P ress the ► button to change PIN LOCK PROTECTION
mode.
4. Please enter the original PIN code.
(a) If the PIN is correct, system will allow you to change
(b) If the PIN is incorrect, a " Code Error " message will appear.
5. Please enter a new PIN code. And then enter again to confirm.
EXECUTE
NOTE:
(1) To change the PIN lock protection state, you must
(2) Please enter: 0000 for first-time use.
(3) Write your selected password down here in this
(4) To avoid unnecessary trouble, if you activate the [PIN
Description
power has been switched off.
is turned on.
CAUTION:
a new PIN code.
enter the PIN code first.
manual to help you remember it; see the selection
"Appendix".
Lock Protection], it is highly recommended that you
write down the PIN code and store it in a safe place.
3
Step:
1. U se the ▲ /▼buttons
to select an item.
2. U se the ◄ / ► buttons
to select an item or
adjust the value.
PJL7200/PJL7201/PJL7202
Advertisement
Table of Contents
