ViewSonic PJD5351 User Manual page 42

Function
(default setting/value)
Timer
Controller
(Disable)
Splash
Screen
(ViewSonic logo)
Quick
Cooling
(On)
High Altitude
Mode
(Off)
DCR
(Off)
Active VGA
Out
(On)
Audio
Settings
Menu
Settings
38 Operation
Description
Sets the auto-shutdown timer. The timer can be set to a value
between 30 minutes and 12 hours.
Allows you to select which logo screen will display during
projector start-up. Three options are available: ViewSonic logo,
Black screen, or Blue screen.
Selecting On enables the function and the projector cooling time
will be shortened to a few seconds.
If you attempt to restart the projector right after the quick
cooling process, it may not be turned on successfully and
will rerun its cooling fans.
A mode for operation in high altitude areas. See
high altitude environment" on page 32
Enables or disables the DCR (Dynamic Contrast Ratio) function.
Selecting On enables the function and the projector will
automatically switch the lamp mode between normal and
economic modes according to the input image detected.
This function is only available when a PC source is in use.
After enabling DCR, frequent lamp mode switching may
shorten lamp life and noise level will vary during operation.
Outputs a VGA signal when the COMPUTER IN and
COMPUTER OUT sockets are correctly connected to devices.
See "Connecting a monitor" on page 14
connection.
Enabling this function slightly increases the standby
power consumption.
Mute (Off)
Volume (5)
See "Adjusting the sound" on page 32
Menu Display Time (15 sec)
Sets the length of time the OSD will remain active after your last
key press. The range is from 5 to 30 seconds in 5-second
increments.
Menu Position (Center)
Sets the On-Screen Display (OSD) menu position.
(default setting/value)
"Operating in a
for details.
for how to make the
for details.