Jabra FreeSpeak BT200 Manual page 5

6
Preparing Your JABRA FreeSpeak
Charging the batteries and talk time
Before using FreeSpeak you will need to put the headset in its
multi-adapter and charge it fully. (The headset may be either on or
off). Insert FreeSpeak carefully by holding it on both sides and
pushing it in while rotating counterclockwise, as shown below. To
remove the headset, carefully hold the headset on both sides and pull
while rotating clockwise, following the same sequence shown below,
but in reverse.
1
To begin charging:
1. Plug the AC power adapter into the multi-adapter.
2. Plug the AC power adapter's plug into an electrical wall outlet.
3. While charging, the indicator light on the headset and multi-adapter
are lit, and remain lit, until both the headset and multi-adapter are
fully charged. The FreeSpeak headset indicator light will only turn
on if the headset is fully inserted into the multi-adapter.
4. Charge the unit for approximately 2 hours or until both indicator
lights go out.
5. You can now remove the headset from the multi-adapter.
If you remove your headset from the multi-adapter (with the AC
power adapter plugged in), then your headset will automatically turn
on (standby mode). If there is an incoming call and your headset is in
the multi-adapter (with the AC power adapter plugged in), then you
can answer as described in Answering a call.
Full charging provides up to 3 hours of talk time or up to 96 hours
of standby time. FreeSpeak's batteries do not need to be completely
used before charging. If the charger is left connected, it will not
overcharge the batteries.
Low Battery Warning Indicators: The headset needs to be recharged
(steps 1-5) when you hear 3 rapid high-pitched tones through the
headset's speaker at 30 second intervals, or when you see the
indicator flash quickly 3 times every 3 seconds. Once the low
battery indicators start, you have approximately 3 to 5 minutes of talk
time remaining.
Turning your headset ON and OFF
To turn your FreeSpeak on:
1. Ensure the AC power adapter is not plugged in.
2. Remove the headset from the multi-adapter.
2
3. Press and hold the
the indicator light emits a very short burst of flashes and the
speaker emits a quick series of tones in ascending order.
4. Without delay, release the button.
An indicator light on the outside of your FreeSpeak will flash every
3 seconds while the headset is turned on. The headset is now in
'standby' mode and ready for use. If you remove your headset from
the multi-adapter (with the AC power adapter plugged in), then your
headset will automatically turn on (standby mode).
To turn your FreeSpeak off:
1. Press and hold the
until the indicator light emits a very short burst of flashes and the
speaker emits a quick series of beeps in descending order.
2. Without delay, release the button.
The headset is now turned off. There will be no indicator light activity
in this mode. You will need to wait 5 seconds before turning it on
again. As long as you are recharging your headset regularly, you do
not need to turn your headset off after using it – you only need to
'end the call' (see Ending a call).
button firmly for at least 3 seconds until
button firmly for at least 3 seconds
7