Table of Contents
Advertisement
G. Install the Loading Motor and tighten screw (S1) as shown in
Fig.
S8.
2.3.4. CYLINDER UNIT REPLACEMENT
NOTE:
Replacing only Upper Cylinder unit of R4 Mechanism cannot be performed, as securing of RT
gap is impossible out of factory, please replace the cylinder by whole Cylinder Unit. The
Compatibility Adjustment should be performed after replacement ofthe DD Cylinder Unit.
1. Remove the Mechanism Unit from Main C.B.A./Chassis by
referring to "Disassembly Procedure".
2. Remove a red Screw (S2) and 2 gold Screws (S3) to remove the
Cylinder Unit shown in
Fig.
S11.
Fig. S11
13
Advertisement
Table of Contents
