Table of Contents
Advertisement
How to cool the heating element
(Fig. H)
When the temperature of the
heating element is too high to
dispense coffee, buttons (20) and
(21) flash
simultaneously.
The heating element must be cooled down
if you wish to prepare a coffee immediately
after frothing milk.
If the heating element is not cooled down, the
coffee dispensed will taste burned.
To cool it quickly, proceed as follows:
• Position a container underneath the steam
wand (7) and turn the steam knob (8) anti-
clockwise to dispense hot water.
• The steam wand (7) will initially dispense
steam. Burns hazard. Successively, hot
water will be dispensed. This means that
the heating element has reached the correct
temperature to dispense coffee.
• Turn the steam knob (8) clockwise and
prepare the coffee.
3.5 Dispensing hot water
H)
•
Turn the machine on using the ON/OFF
switch and wait until the coffee dispensing
LEDs have a fixed light.
• Position a recipient under the steam wand
(7).
• Turn the steam knob (8) anti-clockwise and
dispense hot water.
• Stop dispensing by turning the steam knob
(8) clockwise.
EN - 8
Use
3.6 A c c e s s i n g
programming menu and
changing the settings
• Make sure that the machine is ready for
use and maintenance. Press the key (23)
for 5 seconds until all keys start to flash:
the machine is in programming mode.
• Set the machine to meet your requirements
(see the next page).
• To exit the menu, wait for 30 seconds
without pressing any key.
Setting the coffee temperature
• Access the programming menu.
• Press the key (20) to set the temperature of
the coffee.
• The key (20) flashes 3 times, after which
the current setting LEDs turn on:
LEDs
(Fig.
• The LEDs start to flash in sequence.
• Press the key corresponding to the desired
temperature: low (20), medium (21) or high
(22).
• The key selected flashes to indicate the
selection has been stored and a single
sound is emitted if the acoustic signals are
activated.
t h e
Setting the
temperature
Low
Medium
High
Advertisement
Table of Contents
