Table of Contents
Advertisement
Cabinet Setup (cont.)
Bakery Case Shelving Installation
1. Without disconnecting the elastic tubing, lift each door up out
of its track. Stretch the elastic surgical tubing and set the doors
on each side of the unit.
2. Locate the shelf supports and install the teeth-end into the
stainless pilasters on the interior walls at the desired height
(see fig. 6). Install as matching left and right pairs at the same
height.
3. Locate the horizontal lights. Hook the light assembly on
the shelf supports positioned light-side down and with the
electrical cords on the right. See fig. 7.
4. Slide the light assembly forward until it sits in the front notch
of the shelf support.
5. Position the stainless steel shelf on the shelf support.
6. Plug the shelf lights into the receptacle.
NOTE: Lights will not operate if they are not plugged in or
the plug cover is not plugged in.
7. Reinstall the doors.
Wire Shelf Installation
1. Without disconnecting the elastic tubing, lift each door up out
of its track. Stretch the elastic surgical tubing and set the doors
on each side of the unit.
2. Locate the shelf supports and install the teeth-end into the
stainless pilasters on the interior walls at the desired height.
Install as matching left and right pairs at the same height.
3. Hook the rear shelf brackets over the rear notch of the shelf
supports. See fig. 8
4. Locate the horizontal lights. Hook the light assembly on
the shelf supports positioned light-side down and with the
electrical cords on the right.
5. Slide the light assembly forward until it sits in the front notch
of the shelf support.
6. Position the top shelf on the top light assembly and rear
bracket.
NOTE: Be sure the tray stop is positioned face up and
towards the cabinet front.
7. Snap the shelf into the clips on the rear bracket. See fig. 9.
8. Plug the light into the receptacle. See fig. 9.
NOTE: Lights will not operate if they are not plugged in or
the plug cover is not plugged in.
9. Repeat steps 6-8 for the remaining shelves.
10. Reinstall the doors.
Page 10 of 18
TCGG
Fig. 6. Hook the shelf supports into the pilasters at the desired height.
Fig. 7. Position the light assembly
hooked on the shelf support and
seated in the notch.
Fig. 8. Position the rear brackets over
the rear notch.
Fig. 10. Repeat the procedure for the
remaining shelves.
03/24/2021
truemfg.com
Fig. 9. Be sure the wire shelves snap into
the clips on the rear brackets. Plug the
light into the receptacle.
TEC_TM_122 | REV. A | EN
Advertisement
Table of Contents
