Table of Contents
Advertisement
Table 8: Driver Parameters (Continued)
SilFlags = n
SimulateDevice = n
SnsALL = n
Topology = n
TrafficCop = n
AB466A and AB467A PCI-X Host Bus Adapters for 64-Bit Windows Systems Installation Guide
Parameter
Values from 0-2. Default = 0. Controls which driver
interface to use. 0 = automode; attempt SLI-2 first. If that
fails, uses SLI-1. 1 = always use SLI-1. 2 = always use
SLI-2.
Values 0 or 1. Default = 0. 0 = do not create a "dummy"
disk device. 1 = create a dummy disk to force the driver to
load even if no disk devices are present at boot time.
Values 0 or 1. Default = 1. Controls which N_Ports are
queried from the NameServer. 0 = SCSI FCP only. 1 = All
N_Ports.
Value 0 through 3. Default = 2. 0 = FC_AL (loop), 1 =
PT-PT Fabric, 2=FC-AL first, then attempt PT-PT,
3=PT-PT first, then attempt FC-AL. When set to 1,
FLOGI, SCR/RSCN and NameServer queries are
employed.
Values 0 or 1. Default = 0. 1 = enable FC-AL loop master
to run unfair and break potential arbitration problems by
sending frames to itself. 0 = run fair all the time.
Diagnostic and Configuration Utilities
Description
43
Advertisement
Table of Contents
