Handwheels
Components and Hardware Needed:
Handwheels ....................................................... 2
Handwheel Handles .......................................... 2
Tools Needed:
Phillips Head Screwdriver ................................. 1
Wrench 14mm .................................................. 1
To install the handwheels:
1.
Remove the two screws and flat washers
already mounted to the handwheel shafts.
2.
Secure the handwheels to the shafts with the
hardware removed in Step 1.
3.
Secure the handwheel handles to the
handwheels, as shown in Figure 16.
Figure 16. Securing the handwheel handle.
G0586 8" X 75" Deluxe Jointer
Knife Setting Jig
Qty
Components and Hardware Needed:
Knife Setting Jig Rod ......................................... 1
Knife Setting Jig Foot ........................................ 2
E-Clip ................................................................. 4
Qty
Assemble the knife setting jig as shown in Figure
17.
Figure 17. Knife setting jig assembly.
Qty
-17-