Star micronics laser printer operations manual (126 pages)
Summary of Contents for Star Micronics DP8340 Series
Page 1
Repair Manual DP8340 Series Edition Issued Date: June 11, 2008 Star Micronics America, Inc.
Page 2
About This Manual The confidential information of Star Micronics America, Inc. or its associated company is recorded in this book. So a user has to treat the information concerned as private information. A user must not use this confidential information except for the purpose of the product repairs.
Page 3
Change Record Rev. # Date of Issue Note 06/11/2007 Release 1st Edition Star Micronics America, Inc.
(1) Remove Mechanism Chassis Unit-------------------------------------5 Removing Print Head (1) Remove Print Head--------------------------------------------------------6 Removing Ribbon Base Unit (1) Remove Ribbon Base Unit ----------------------------------------------7 Removing Main Control Board (1) Remove Main Control Board--------------------------------------------8 2. Notice of the repair operation----------------------------------------------------------9 3. Parts List-------------------------------------------------------------------------------------10 Star Micronics America, Inc.
Please confirm before repair Turn off the Power Switch and disconnect the Power Cable from the outlet. 1. Repair Mechanism (1) Remove Printer Cover Unit 1-1) Starting from back side gently pull toward front as shown below. Star Micronics America, Inc.
(1) Remove Upper Case Unit (You must remove lower case first) 1-1) Remove screws (2) from bottom of printer as shown below. 1-2) Turn printer over and pull cover front to back to loosen that pull forward as shown below Star Micronics America, Inc.
Page 7
1-3) Disconnect Control Panel Unit (part # 87200310) Star Micronics America, Inc.
1-3 Removing Control Board Unit (1) Remove Control Board Unit 1-1) Remove screws (2) and remove from Upper Case. 1-2) Control Panel Unit shown below Star Micronics America, Inc.
(1) Remove Mechanism Chassis Unit 1-1) Remove screws (4) and flat washers identified by red arrow 1-2) Disconnect frame wires located circled area 1-3) Disconnect the two (2) connectors on Terminal board and gently lift Mechanism. Star Micronics America, Inc.
1-1) Remove Cover Unit as outlined in section 1.1 Remove Upper Case as outlined in section 1.2 1-2) Disconnect Print Head cable A as shown below 1-3) Remove Print Head screws as shown below B 1-4) Remove Print Head 1-5) Star Micronics America, Inc.
Remove Cover Unit outlined in section 1.1 1-2) Remove Upper Case Cover outlined in section 1.2 1-3) Remove Springs on both sides as shown below 1-4) Snap Base Unit away from Mechanism 1-5) Slide Ribbon base towards right side and remove Star Micronics America, Inc.
Remove Ground wires black (3) from Mechanism outlined in section 1.4 1-4) Remove screws (4) from bottom plate of printer as shown below. 1-5) Separate Control Board and Chassis Unit from Lower Case 1-6) Remove from Chassis Unit Example 1.4 Chassis Unit Example 1.6 Star Micronics America, Inc.
(13) The control board should be passed the customer’s testing. Because our product may be destroyed if control board is broken. (14) Since the causes of generating differ, please distinguish and manage the defect products in a receiving inspection and the assembly line’s inspection. Star Micronics America, Inc.