3-2. STANDARD DISASSEMBLY DRAWINGS
► This is a standard disassembly diagram and may differ from the actual product.
Use this material as a reference when disassembling and reassembling the product.
Part
Sub and Main PCB
Assembly
Figure
Description
1. Remove the 5 screws holding the control
panel assembly.
2. Separate the assy panel upward with the door
slightly open.
3. Separate the hass wire from cover connector
and wires connected to the sub PCB.
4. Pull the knob encoder to separate it and then
remove the 2 fixing screws.
5. Separate wire connected to the touch module
and 4 hooks.
6. Separate hooks and remove 1 screw.
When reassembling the PCB, take care
that you do not damage the control-panel
fixing hook. After replacing the sub PCB,
check the key operation.
6. Remove the 3 screws and then separate the
cover pcb(m), wires connected to the main PBA.
After reassembling the housing, check
if the wires are properly connected.
When disassembling and reassembling
the housing, take care that you do not
damage the part.
Disassembly and Reassembly _ 11