Installation Checklist - Trane R8GE Series Installation Instructions Manual

INSTALLATION ADDRESS:
CITY:
UNIT MODEL #
UNIT SERIAL #
Unit Installed Minimum clearances
per Figure 1 (page 32)?
INSTALLER NAME:
CITY _________________________________________
Has the owner's information been
reviewed with the customer?
Has the Literature Package been left
with the unit?
ELECTRICAL SYSTEM
Electrical connections tight?
Line voltage polarity correct?
Rated Voltage: ................................................................. VOLTS
L1-L2 Volts: ______________________________________________________________________ VOLTS
Has the thermostat been calibrated?
Is the thermostat level?
Is the heat anticipator setting
correct? (If Applicable)
VENTING SYSTEM
Is the vent hood installed?
Is vent hood free from restrictions
Filter(s) secured in place?
Filter(s) clean?
Specifications & illustrations subject to change without notice or incurring obligations (09/18).
O'Fallon, MO, © Nortek Global HVAC LLC 2018. All Rights Reserved.

INSTALLATION CHECKLIST

STATE:
YES NO
STATE _____________________________
YES NO
YES NO
YES NO
YES NO
YES NO
YES NO
YES NO
YES NO
YES NO
YES NO
YES NO
GAS SYSTEM
Gas Type: (circle one)
Gas pipe connections leak-tested?
Gas Line Pressure: .......................................................... (in - W.C.)
Is there adequate fresh air supply
for combustion and ventilation?
Installation Altitude: ......................................................... (FT.)
Deration Percentage: ....................................................... (%)
Unit Input: ........................................................................ (Btuh)
Supply Air Temperature: ................................................. (° F)
Return Air Temperature: ................................................. (° F)
Temperature Rise: .......................................................... (° F)
DURING UNIT OPERATION:
Manifold pressure: ........................................................... (in - W.C.)
REFRIGERATION SYSTEM
Was unit given 24 hr warm up
period for crankcase heaters
(if equipped)?
Stage-1 Liquid Pressure (high side)
Stage-1 Suction Pressure (low side)
ATTENTION INSTALLERS:
It is your responsibility to know this product better than your customer. This
includes being able to install the product according to strict safety guidelines
and instructing the customer on how to operate and maintain the equipment
for the life of the product. Safety should always be the deciding factor when
installing this product and using common sense plays an important role as well.
Pay attention to all safety warnings and any other special notes highlighted
in the manual. Improper installation of the unit or failure to follow safety
warnings could result in serious injury, death, or property damage. These
instructions are primarily intended to assist qualified individuals experienced
in the proper installation of this appliance. Some local codes require licensed
installation/service personnel for this type of equipment.
Natural
Propane
Gas
YES NO
YES NO
YES NO
10239640
(Replaces 709664B)